![ecu flashing motorcycle ecu flashing motorcycle](https://www.euro-racing.it/4824-thickbox_default_2x/woolich-racing-ecu-flashing.jpg)
Most people are opting for a 500-1000 RPM increase over the stock value. This increases the rev limit on the bike.It also can cause popping on deceleration when off of the throttle.
#ECU FLASHING MOTORCYCLE FULL#
#ECU FLASHING MOTORCYCLE SOFTWARE#
Not an issue in the US as the US bike doesn't have one, but on the Euro bikes, I can remove this via software so you can remove the O2 sensor from your bike.So if you're doing top speed runs out in say, the Bonneville salt flats, you can run the required gearing needed to achieve the maximum speed you want. The bike no longer has an electronic speed limiter.What added benefits are included in the flash? There are also several other benefits that are included in the flash. This ECU flash returns that power that was electronically eliminated, to you the rightful owner of the bike that you purchased. If you dyno tested a 100% stock, European spec 2011+ ZX-10R and a 100% stock, American spec 2011+ ZX-10R, the European bike would dyno 15-20 horsepower HIGHER than the American bike, simply because of these changes.
![ecu flashing motorcycle ecu flashing motorcycle](https://www.veloxracing.com/wp-content/uploads/2015/09/2015-r1-race-team-screen-shot.png)
These changes caused the overall output power of the bike to suffer. Specifically, on the 2011+ ZX-10R, output power was intentionally or not limited because of the noise and emissions standards the EPA has established in the US.
#ECU FLASHING MOTORCYCLE INSTALL#
You then install the ECU to your bike and see immediately what you've been missing.
![ecu flashing motorcycle ecu flashing motorcycle](https://www.jetttuning.com/wp-content/uploads/2012/11/ECU300.jpg)
I then package everything up and send it back to you (overnight in the continental US, with tracking, $1000 insurance and signature required). After that, I sign off on the report I generate specifically for you, showing what changes were made, why they were made as well as initial off functions as they have been tested and confirmed to work. I then hook up the ECU to my own bike and test to make sure all the changes took effect. I then shut down the ECU by removing power and reconnect it to verify that the changes took effect. After that, I hook up your ECU to my computer via a special interface and rewrite the values stored on the ECU. After I receive it, I verify what settings or changes you want and make the changes in my software. ECU flashing is taking the ECU out of your motorcycle (or other fuel controlled vehicle) and overwriting the values inputīy the manufacturer typically for the purpose of gaining power from your vehicle or enabling or changing special functions such as traction control or eliminating manufacturer limitations such as electronic governors and such.įirst your ECU needs to be removed from your motorcycle and sent to me.